Skip to content

Water World: A well-watered resting place

|
Chattanooga Cemetery (Photo: Dan Stacey)
Chattanooga Cemetery (Photo: Dan Stacey)

Location: Chattanooga, Tenn.
Company: Landscape Services Inc.

Installing an irrigation system is never an easy undertaking. Add a cemetery to the mix, and not only do you have to dig trenches around the usual water lines and tree roots, but you also have to avoid gravesites. That’s what Landscape Services Inc. (LSI) did when it installed a new irrigation system at the Chattanooga National Cemetery.

The main challenge was ensuring the crew’s hand tools and Ditch Witch ride-on trenchers never encroached on the tombs. It was a major concern because the cemetery superintendent didn’t have precise tomb measurements or locations. Additionally, construction had to be coordinated around the cemetery’s burial schedule, says Paul Stacey III, vice president of construction services at LSI. “Unfortunately, they were burying someone daily,” Stacey says. “They didn’t have any burials too late, so the work was heavy in the mornings and heavy in the evenings.”

The crews were careful to never leave their work unfinished at the end of the day. They completed one valve at a time and covered the irrigation pipes and valve boxes the same day. Despite the challenges, which also included boring underneath a road and hand digging several sections of the system, Stacey says he and his crew were honored to work on the grounds at the national cemetery. “I took more pride in my work than I maybe normally would have because of the property,” he says.

Photo: Dan Stacey
Photo: Dan Stacey

These after pictures were taken in August and as you can see, the grass is very healthy and vibrant, even during the hottest part of the year.

Photo: Dan Stacey
Photo: Dan Stacey

There are 55 Quick Disconnect valves on the site, eight of which can run at the same time, producing excellent efficiency.

Photo: Dan Stacey
Photo: Dan Stacey

To not disturb any tombs, the rollability of these wheel hoses is the key for flexibility throughout the cemetery.

Photo: Dan Stacey
Photo: Dan Stacey

The valve boxes are nearly invisible when closed, as to not disturb the environmental look.

Photo: Dan Stacey
Photo: Dan Stacey

This is a look at the sealed boxes that cover the backflow preventer, pressure tank and the booster pump.

Photo: Dan Stacey
Photo: Dan Stacey

This pressure tank controls the underground water lines with 400 psi of pressure in order for the water to move quickly through the four miles of pipe.

Photo: Dan Stacey
Photo: Dan Stacey

Here is a look at the 3-inch backflow preventer that was installed on a very cleanly poured slab of cement.

Photo: Dan Stacey
Photo: Dan Stacey

An in-progress picture of the same area as picture one. Lots of disturbance to the existing grounds with the trencher.

Photo: Dan Stacey
Photo: Dan Stacey

The Chattanooga National Cemetery has beautiful Bermudagrass throughout. Keeping it watered is key to its health.

Photo: Dan Stacey
Photo: Dan Stacey

An in-ground look at the massive Quick Disconnect valves that were installed with a concrete backing for extra support from the water pressure.

Photo: Dan Stacey
Photo: Dan Stacey

Prior to back-filling the hole, extreme importance to the client was to have the irrigation boxes level with the ground, to not sink.

Photo: Dan Stacey
Photo: Dan Stacey

Covering 115 acres of Bermudagrass is the task of these irrigation sprinklers.

Photo: Dan Stacey
Photo: Dan Stacey

This booster pump connected to the pressure tank works in sequence to allow the proper flow.

To top